reorder

Premium 3D Printer Filament PLA-spool , 1 Kg/spool, White / 1.75 Mm / 1 Kg

About The 03mm
  • Nominal processing temperature of 210°C (410°F)
  • 195mm reel diameter, 95mm hub diameter, 38mm spindle diameter, 80mm reel width
  • 1 Kg reel
  • Extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0..

    The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. It has a nominal processing temperature of 210° C (410°F)

  • Get outstanding 3D printing results when you use 1.75mm PLA 3D Printer Filament from Monoprice!

    PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle. 

    This 1 kg spool features a thickness of 1.75mm x 0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 210° C (410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.

    The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.

    Features:

    • 1.75mm x 0.10mm PLA filament with roundness variation of less than 0.03mm
    • Nominal processing temperature of 210°C (410°F)
    • 195mm reel diameter, 95mm hub diameter, 38mm spindle diameter, 80mm reel width
    • 1 Kg reel
    • Extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%)
    • PLA is a plant-based plastic, which means that it is biodegradable and gives off a slightly sweet odor, like roasting corn

     

    Support Files:

    • Filament Comparison Chart

    3D Printer Filament

    Premium 3D Printer Filament PLA-spool , 1 Kg/spool, White / 1.75 Mm / 1 Kg

    3D Printer Filament

    Specifications of Premium 3D Printer Filament PLA-spool , 1 Kg/spool, White / 1.75 Mm / 1 Kg

    Category
    Instockinstock

    Last Updated

    Premium 3D Printer Filament PLA-spool , 1 Kg/spool, White / 1.75 Mm / 1 Kg
    more variety

    . It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0..3%)

    Rating :- 9.49 /10
    Votes :- 186